Trane Fan Coil Unit Heater

Plate type heat exchangers.

Trane fan coil unit heater.

Oil and vacuum pumps. Environment trane manufacturing sites in. Nevertheless it is recommended to wear gloves when handling units and during the installation. Safety the make the installation of the product and its maintenance safer all casings of the unitrane fcd fed range are manufactured without sharp edges where possible.

These air terminal devices and heating products offer high quality controls for efficient operation and flexibility construction that can assure easy installation and service. Tools for copper. Their ease of installation rugged construction and architectural styling particularly suits them for space heating applications in commercial industrial and institutional applications. The fan is driven by a low speed 600 rpm four pole motor and is controlled by a tamperproof built in thermostat calibrated for an operating range of 55 f to 85 f.

For durability the heater grille consists of individual louvers reinforced by 0 09 inch vertical steel bars. All vertical unit heaters are shipped fully assembled and may be used for steam or hot water applications. Trane s commitment to customer s needs for quality effi ciency and reliability is evident from the largest chiller to smallest fan coil trane s commitment to customer s needs for quality effi ciency and reliability is evident from the largest chiller to smallest fan coil. The trane electric architectural forced air wall unit heaters combine quiet reliable heating with an attractive cabinet design.

Fan coil unit parts. Unless otherwise specified the following conversions may be used for calculating si unit measurements. Fans are balanced and motors are prelubricated. Water to refrigerant heat exchangers.

Control options range from a simple fan speed switch to a ddc controller that can tie into a tracer summit building automation system. Trane unitrane fan coil units meets the standards of today s market and anticipate the needs of tomorrow s. 1 foot 0 305 m 1 inch 25 4 mm. Coils are factory tested at 400 psig air under water.

Coils are factory tested at 250 psig 1723 5 kg. Reheat coil piping is available on 2 pipe units with hot water reheat coils and either a fan speed switch or tracer zn520 and uc400 b. All unit housings are constructed of 20 gauge steel.