Tractor Splitting Stand Ideas

All powder coating is completed by.

Tractor splitting stand ideas.

It has 6 casters for easy rolling. My cross beam is as wide as the rear tires are for stability. My next plan was to use the square hole in the bolster for a tripod setup using three trailer jacks. My stand goes farther back on the next set of holes in the drive shaft tube much closer to the centerline of the tractor.

This stand weighs in at about 75 lbs. This stand fits most all tractors with side rails. Min height 14 5. I currently have a set of splitting stands that were made by the poor brothers in ohio.

Supports weight of 10 000 lbs. The following pictures and information show how a couple individuals ford tractor and. Tractor splitting stands with rails part. Per jack stand.

This tractor splitting system is designed to assist service technicians with process of splitting tractor effortlessly efficiently and safely while performing tractor repairs maintenance and inspections. Jim b march 2 2019 at 5 30 pm. It fits all tractors frame or frameless 2 or 4 wheel drive. My front stand has a leveling jack from a set of scaffolding on each side on the front with an adjustable brace with large setscrews to lock them to near the front of the tractor on each side.

I never have likes splitting stand but i do use an over head i beam and 4 chain hoists to split tractors. In most cases there are no bolts or jacks to adjust but they can be used when needed. Ed gooding a number of people have come up with devices to help them split their tractors for service and move around sections of their tractor by themselves. I could bring the m670 over and give you a hand.

It has easy to use telescoping adjustments two. Easy to install only requires four bolts. The easiest to make rear one is one that has one caster in the center pivots on a bracket bolted to the front of the transmission with a 3 4 by 8 setscrew to adjust the height. Marvin baumann ultradog mn patrick knight and steve dabrowski compiled and edited by.

Cofer s heavy duty front splitting stand weighs 320 and will adjust from 18 1 2 in the low position to 52 in the high position. They actually sold a set of stands together that you can use to stand the front and rear halves separately they are elegant and work great. Splitting stand ideas discussion in the farmall international harvester ihc forum at yesterday s tractors. Orin well as a matter of fact it is holding up a mf tractor and yes you are correct.

Coming soon i will have an attachment to bolt the front splitting stand to the engine of a farmall a b c tractor. Built from heavy gauge material it will handle those big tractors. They were generously loaned to me by craig magnumpi for when i was doing the front seal on my tractor. Where in the uk ru i would love to borrow iti have a.

Contact me to purchase. The stand installs in 2 minutes with no lifting. I used a steel angle as a cross beam to two trailer jacks. As you may know floor dry is not allowed only sawdust is allowed.

Muddy a better idea is not to split a tractor. No that is not uncle s shop.