Treads and landing are pre drilled to receive trex tread board.
Trex stair tread installation.
Make sure 53 135 6 cm posts are used for all stair posts.
Trex select railings are designed to be installed over the decking frame or on inside of rim joist.
Ensure that baluster spacer holes are.
Place universal rail remembering to orient this properly so that when flipped over the universal rail will accept the baluster spacer and balusters on the 2 x 4 51 mm x 102 mm centered.
Place inverted 2 x 4 51 mm x 102 mm place top side down on clean flat surface.
Deckboard on the nose of the stair tread.
For more videos and installation.
Notching of pressure treated posts or posts installed on outside of rim joist is not allowed.
This is the stair video.
This is a cut line to allow you to shift the entire set of stairs down.
Part 4 of our deck series.
Tres has your basic guide to installing trex transcend deck railing.
Use the lower and upper stair post to set the length of the bottom stair rail.
At the bottom step subtract the thickness of a tread from the rise and mark a line perpendicular to the rise.
Start clip metal clips used at the end of decking boards to secure them in position.
Hope you all enjoy.
If trex signature stair posts are used install at nose of stair tread directly under required blocking.
Stair tread steps or stairway boards that are the steps.
Want to install beautiful stair railing for your deck.
1 25mm if installing in localities prone to large temperature shifts within a 24 hour period and installing trex universal hidden fasteners predrill and toenail a screw use same screw used in hidden fasteners at an angle in groove at both ends at least 1 25mm from board end and center of each board.
100 composite with no visible pressure treated wood on the stairs.
Snap baluster spacer into bottom stair rail and lay bottom stair rail on top of the deckboard 5.
If using aluminum balusters use a scrap piece of wood measuring at least 1 11 16 thick and place on the nose of the stair tread.
Stringer the structural member in a stairway that supports the treads and risers.
Ships with a 10 x 1 4 thick round metal base plate with pre drilled holes for bolting to landing pad.
Trex select stair railing installation instructions important notes.
Post to post span will be less than 6 or 8.
Prior to installing posts calculate post to post span using a maximum rail.
Unique lip up tread design for added strength and safety.
Heavy duty treads and landing are welded to a round collar that precisely slides over the 3 1 2 diameter center pole.